f44s blockmaking

The excellent characteristics of the F44S make it one of the most desirable and versatile block producing machines available. As this machine has evolved, it has proved its strengths, shown its qualities and reliability over many years. The SRS Finlay F44S is the most dynamic fully automated machine, anywhere in the world.

• Electronic/Hydraulic – 380-400 Volt Phase, 50 Hz
• Diesel/Electric/Hydraulic powered via on board 6cyl. diesel/56kva
• Fully automatic machine with pre-programmed control
• Automatic in-row steering, via infrared guidance system
• Hard-wired remote control unit for added safety in mould changing
• Unique easy-fit mould box. No need for entry into the danger area
• New hydraulically clamped, quick fit tamper head carriage
• One full set of heavy duty high frequency interchangeable mould vibrators, comprising of 4 vibrator elements with variable amplitude, each with individual electric motor drive, complete with mounting plates, leads, and plugs
• Pre-wired with 2 no. plug sockets for tamper head vibrator units
• Maximum mould area is 1160mm x 914mm
• Cycle Time is typically 25-30seconds depending on application
• Product height range 190mm – 450mm
• Safety guards all round with captive key locking system
• Factory fitted options, Auto lubrication for all grease points
• Hopper capacity 2.5m³ max
• Capable of 4400, 100x215x440mm Solid blocks per hour
• Produces Solid and Hollow blocks
• Capable of 1200, 200x200x400mm Hollow blocks per hour
• Produces Solid and Hollow blocks

Tamper Head Carriage Quick Release

The benefit of this is that it radically speeds up mould change times, plus the added advantage of keeping the operator out of the danger zone when fitting the Tamper Head. When fitting a Mould and Tamper Head, the carriage is lowered down, the quick release carriage picks up the head and is held firmly in position. A securing bolt is then fastened between both carriage and Tamper Head as an added safety measure. Mould change will be completed in approx 20mins.

Panel View

This allows a new electrical control and fault diagnostic system, which allows the operator to monitor and control machine operations. It works through a touch screen display within the operator cab; this screen has all the functions to setup the machine to the desired operating sequence. Pre-vibration times, final vibration time and the number of tamps are changed automatically within the software. If the machine stops anywhere in its operating sequence, a screen display will show where the stoppage has occurred and a description of the fault will be displayed.

Download brochure Download brochura